Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
dodge ram error calibrating with calterm
#1
CM2350B Central

Error when it reaches 100% recording with calterm IV

Incal DO90036.02

I've already tried for both cans and already enabled the parameter "C_J1939_GTISCompliant" in the calibration
   
any tips on where i'm going wrong?


Attached Files Thumbnail(s)
   
#2
From what i have understood you need efilive to unlock/disable dodges security bs first
#3
(09-29-2021, 07:51 PM)IceXN Wrote: From what i have understood you need efilive to unlock/disable dodges security bs first

It can be done in Calterm, but yes the ECU must be in 'Unlocked' state first before you can do anything.
If I helped in any way, please give THANKS + REP!

Cummins INSITE 8.x+Fleet Cals, Password Resets
Cummins Calterm 5.12.1
Calterm Master Tool v9.4
Cummins INCAL Tool v7.0
CNH 9.2 Dealer or Engineering
Wabco 13.6 Engineering
DDDL 8.19 - Levels 10/10/10
CAT ET 2023A + Perkins 2023A + FPKG/AutoGen
SR 4.11 Engineering
Bendix ACOM Pro 2023
Allison DOC 2023
JPRO 2023
Remote Tuning for all Cummins engines. PM for Quote.
#4
(09-29-2021, 07:51 PM)IceXN Wrote: From what i have understood you need efilive to unlock/disable dodges security bs first

What would unlock/disable be?

Calibration DO90037.01 writes 100% to the control unit via calterm IV.
Without crashing at 100%.

Calibration DO90036.02 hangs after 100%. I have to unlock by 5volt jumper.



Edit......

Calterm IV manages to "'Unlocked'" in "efilive"
#5
personally ive never tried it, and I use Calterm 5.3
  


Forum Jump:


Users browsing this thread:
1 Guest(s)