Thread Rating:
  • 3 Vote(s) - 4 Average
  • 1
  • 2
  • 3
  • 4
  • 5
problem with cm2250
#4
[attachment=187 Wrote: Sensei pid='413' dateline='1517267741']Which one should I diagnose first? Engine has tapping/knocking that is more noticeable at lower rpm. During regen the exhaust smells in the cab really bad. Cylinder cutout test ran without stalling when isolating each cylinder by themselves. Sounded like shit though. Fuel leak down test was little to no drop in pressure after truck was turned off. EGR diff pressure sensor was changed last year. Removed EGR valve and it looked clean. DPF is not clogged pressure and soot levels are normal/low.

[Image: E7_FBAF45_1964_466_F_82_D3_4_C04335248_F9.jpg]
Two of these codes keep appearing. The EGR fault and the Gas Pressure Sensor fault. Ignore the maintenance code. The other two are new.

Please help thx

First thing is to educate yourself about your engine of your truck and also the EGR.
The CM2250 have to 2 sides for the engine. Left side (Driver side) is the dirty side of engine and Right Side (passenger side) is the clean side of the engine. You have to do more maintenance to the left side.
No matter what type of fault you have active or inactive, pay close attention to. In my opinion an inactive fault is just like an active fault depends how many times it triggers itself.
 
If this my truck this I will go by fixing my problem
1.      I will do a complete egr tune up. “I do mines every other month over the week”
2.      Fault code 3383 Replace your egr pressure sensor
3.      Fault 2764 Replace your Exhaust Gas Pressure Sensor also if you have not change it yet your crank case filter.
4.      Fault 3232 Mostly likely Intake NOx senor is bad. The sensor is right by the turbo next to egr. You would need to diagnose first before replace it, the sensor is expensive so diagnose it will be the way to go. I will clean the connector and pins and put some dielectric grease
5.      Fault 2771 is the same above
6.      If I where I would clean Decomposition tube this will help clear a lot of your trouble up.


Please don't forget to give me thanks and rep if this help....


Attached Files Thumbnail(s)
   
[-] The following 3 users say Thank You to ghostman for this post:
  • Cat-tech, same101us, technik9195
  


Messages In This Thread
problem with cm2250 - by Sensei - 01-29-2018, 07:15 PM
RE: problem with cm2250 - by same101us - 04-11-2018, 06:41 PM
RE: problem with cm2250 - by DanyBoy - 04-11-2018, 07:42 PM
RE: problem with cm2250 - by ghostman - 04-21-2018, 11:10 AM
RE: problem with cm2250 - by technik9195 - 01-14-2019, 11:39 PM

Forum Jump:


Users browsing this thread:
2 Guest(s)