Thread Rating:
  • 1 Vote(s) - 3 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Need ECM image or template for kw900L c
#3
It is not as simple as just having everything turned on in features and parameters, a guy should always make an ECM image in work orders with insite and then make a template file and save it and then load it to ECM after loading a new raw incal to ECM, failure to do so could cause you to lose a lot of your switches and parameters functionality like fan over ride, jakes, cruise control, and ideal ajustment among other things, I went through this, but now I have no template to start with since the Cummins is came out of an international and I am putting it in a 2006 w900L kenworth, don’t know if an870 template would even work with a 2250 since in 2006 that is the version of isx that was sold, also not sure if a 2012 template for a w900 and cm2250 would work with my older 2006 model truck,
  


Messages In This Thread
RE: Need ECM image or template for kw900L c - by cumapart - 01-10-2018, 03:20 PM

Forum Jump:


Users browsing this thread:
1 Guest(s)