ZEZ AUTO > Heavy Vehicles > Heavy Vehicle Tuning > MBE programming question
ZEZ AUTO > Heavy Vehicles > Heavy Vehicle Tuning > MBE programming question

Thread Rating:
  • 1 Vote(s) - 4 Average
  • 1
  • 2
  • 3
  • 4
  • 5
MBE programming question
Lucifer Offline
Tuning Support
*******
Posts: 41
Threads: 2
Thanks Received: 70 in 27 posts
Thanks Given: 97
Joined: Nov 2017
Reputation: 15
ZEZ: 204.76 ZEZ [Buy]
#16
05-07-2018, 12:22 PM
(05-07-2018, 09:39 AM)ISXCUMMINSGUY Wrote: yes but then it sends a signal to the ECM... The ECM is not receiving signal from cab controller. All wiring is ok. So either cab controller messing up or ecm...When you unplug it it does change to open circuit .. the code is for low coolant. Installed new sensor still same. Customer had to use truck so we let it go for now will have it in here another weekend and see what we can do....

If fault changes then it's relaying data and power. What type of sensor is installed? Is it installed upside down?
Reply
  


Messages In This Thread
MBE programming question - by ISXCUMMINSGUY - 05-02-2018, 06:33 PM
RE: MBE programming question - by alicestar - 05-02-2018, 06:44 PM
RE: MBE programming question - by ISXCUMMINSGUY - 05-02-2018, 06:51 PM
RE: MBE programming question - by alicestar - 05-02-2018, 06:53 PM
RE: MBE programming question - by ISXCUMMINSGUY - 05-02-2018, 06:54 PM
RE: MBE programming question - by alicestar - 05-02-2018, 06:59 PM
RE: MBE programming question - by ISXCUMMINSGUY - 05-02-2018, 07:00 PM
RE: MBE programming question - by alicestar - 05-02-2018, 08:58 PM
RE: MBE programming question - by ISXCUMMINSGUY - 05-02-2018, 11:35 PM
RE: MBE programming question - by 4ly-syk - 05-03-2018, 05:41 AM
RE: MBE programming question - by ISXCUMMINSGUY - 05-03-2018, 09:15 AM
RE: MBE programming question - by kamiar - 05-03-2018, 12:06 PM
RE: MBE programming question - by ISXCUMMINSGUY - 05-03-2018, 06:03 PM
RE: MBE programming question - by Lucifer - 05-04-2018, 03:16 PM
RE: MBE programming question - by ISXCUMMINSGUY - 05-07-2018, 09:39 AM
RE: MBE programming question - by Lucifer - 05-07-2018, 12:22 PM
RE: MBE programming question - by ISXCUMMINSGUY - 05-09-2018, 10:19 AM
RE: MBE programming question - by Lucifer - 05-09-2018, 01:05 PM
RE: MBE programming question - by Rocinante - 05-15-2018, 11:25 PM
RE: MBE programming question - by ISXCUMMINSGUY - 05-16-2018, 09:39 PM

Forum Jump:


Users browsing this thread:
1 Guest(s)