ZEZ AUTO

Greetings,

I know there are people here that know a lot about increasing HP and torque in an Engine. I have a question do you guys think that  by in increasing these tables and parameters I would gain more HP and Torque in my engine?

C_AIF_AlphaFuelRateLLim
C_AIF_AlphaFuelRateULim
C_EMM_NTE_Power_Low_Thd
C_EMM_NTE_Speed_Low_Thd
C_INDM_Max_Derate1_Limit_Tbl
C_INDM_Max_Derate2_Limit_Tbl
C_DL_EC_Speed_Point3
C_DL_EC_Speed_Point5
C_J1939_AETC_Trq_Tbl
C_MACH_Torque_1_Tbl
C_MACH_Torque_2_Tbl
C_MACH_Torque_3_Tbl
C_MACH_Torque_4_Tbl
C_MACH_Torque_5_Tbl
C_STRC_MaxLoadTorqueTbl


Any Help Is greatly appreciated.

It looks like you just compared two different CPL INCAL's.
There are many more tables to change, and some of those you don't change in most situations.
Not to mention, you need to adjust fueling, MCF, and start of injection timing, etc etc.

(05-03-2020, 06:13 PM)zyNoT Wrote: [ -> ]It looks like you just compared two different CPL INCAL's.
There are many more tables to change, and some of those you don't change in most situations.
Not to mention, you need to adjust fueling, MCF, and start of injection timing, etc etc.

thank you for your prompt answer, I did get those parameters by comparing two equal cpl calibrations and looking at the differences. Once I wrote down differences, I honestly saw that there were too few changes to increase 50HP. That lead me to take the time and bother you all for your input about my findings.