Posts: 9
Threads: 3
Thanks Received: 3 in 1 posts
Thanks Given: 0
Joined: Dec 2019
Reputation:
0
ZEZ: 968.83 ZEZ
[Buy]
need help with chi table for 871 ive been told to run chi4 all across but would like to know what the other tables do thank you
![[-]](https://www.zezauto.com/images/netpen/collapse.png)
•
Posts: 21
Threads: 4
Thanks Received: 7 in 4 posts
Thanks Given: 4
Joined: Mar 2020
Reputation:
10
ZEZ: 117.01 ZEZ
[Buy]
Alpha0 - cold start also can beused for over-power protection
Alpha1 - steady operating state - full-emissions+egr operating mode below 4,000 feet.
chi2 - steady state high altitude mode above 1200M
chi3 - steady state for high altitude mode above 2400M
chi4 - non-egr + engine protection mode
chi5 - non-egr + engine protection mode high altitude 1200M +
chi6 - non-egr + engine protection mode 2400M+
chi7 - passive regen mode
chi8,9,10 - SCR thermal managment modes, SCR warm up etc. altitude base as well
chi11 - aftertreatment fuel rate limiting
chi12 - engine protection/limp home
Chi13 - stationary regen
Posts: 9
Threads: 3
Thanks Received: 3 in 1 posts
Thanks Given: 0
Joined: Dec 2019
Reputation:
0
ZEZ: 968.83 ZEZ
[Buy]
Thank you for the help ill look into it
•
Posts: 196
Threads: 50
Thanks Received: 744 in 131 posts
Thanks Given: 102
Joined: Nov 2017
Reputation:
603
ZEZ: 46,257.7 ZEZ
[Buy]
You should not have to adjust all the tables. This is bad tuning. You should have engine setup to only use the modes and tables you want. Meaning those other tables don’t need changed because they’re not used. If ECM is setup to go into all modes then you’re not doing it right.
If I helped in any way, please give THANKS + REP!
Cummins INSITE 8.x+Fleet Cals, Password Resets
Cummins Calterm 5.12.1
Calterm Master Tool v9.4
Cummins INCAL Tool v7.0
CNH 9.2 Dealer or Engineering
Wabco 13.6 Engineering
DDDL 8.19 - Levels 10/10/10
CAT ET 2023A + Perkins 2023A + FPKG/AutoGen
SR 4.11 Engineering
Bendix ACOM Pro 2023
Allison DOC 2023
JPRO 2023
Remote Tuning for all Cummins engines. PM for Quote.
